This conversion gives the user the ability to quickly connect and disconnect their hose to their reservoir. This is very useful for when removing the reservoir from the pack for cleaning or for filling. The installation comes down to 3 easy steps.
1) Remove the fixed connector from the reservoir. This can be accomplished by hand. It helps get more leverage, it you leave the hose on the fitting. Give it a quick, sharp tug to the fitting and it should come out. If that doesn't work, pull the hose off and pull the fitting out with a pair of pliers.
2) Install the Plug N Play valve into the reservoir. Simply press it into the port of the reservoir.
3) Install the hose-end fitting. First, remove the fixed connector if it is still attached to the hose. We recommend that it be cut off with a pair of scissors. Second, moisten the barbs on the new fitting and insert it into the tube.
The final step is to apply a small amount of silicone, gycerine, or bees wax to the o-ring on the fitting. Not too much! Just enough to make the o-ring shiny.
That's all. You're done!